How would you go about making it work, I dont have ethernet just the wifi card?

Thanks

We will start by getting information on your wireless card. Issue the following cmd on your terminal:

Code	[In neuem Fenster öffnen]
lspci | grep 802

And if the output is similar to the following, proceed to the next step.

Code	[In neuem Fenster öffnen]
02:04.0 Network controller: Broadcom Corporation BCM4318 [AirForce One 54g] 802.11g Wireless LAN Controller (rev 02)

Download the driver files,

http://rapidshare.com/files/40644803/tecpages.com-bcm4318.zip
PASSWORD : http://tecpages.com

Then install ndiswrapper on your system. For Paldo its installed by default. Install everything from the command prompt or using ndiswrapper front end.

Code	[In neuem Fenster öffnen]
ndiswrapper -mi "path to the inf file"

Verify the installation using,

Code	[In neuem Fenster öffnen]
ndiswrapper -l

Otherwise install ndisgtk with this cmd:

Code	[In neuem Fenster öffnen]
sudo upkg-install ndisgtk

Go on the Gnome-Menu to SYSTEM > ADMINISTRATION > WINDOWS WIRELESS DRIVERS

After entering the root-password click on INSTALL NEW DRIVER to install the windows driver.

also have added a wiki page for Broadcom 43xx chipset wireless for using the linux native driver b43: http://www.paldo.org/wiki/B43Firmware
 
..............................
OSs: Paldo-testing x86_64 :: HP Pavilion dv9680ez

thx for that.